User manual
Default IP Address – 192.168.0.100
Chapter 4 General Procedures
This chapter contains the following general information and procedures:
• Configuring 460 Gateways from a file
• Changing IP or subnet addresses using either IPSetup.exe or the Real Time Automation
460 Gateway web page
Configuring 460 Gateways from a file
If you need to configure many 460 Gateways with the same or a similar configuration, the
quickest and easiest way to do so is to configure the first 460 Gateway using the steps in
Chapter 1, then save that configuration to a file that you can use to configure the other 460
Gateways.
Use the steps in the following section, Creating a configuration file, to create the initial
configuration file. After you have the desired configuration file, use the following steps in
Uploading a configuration file to additional gateways on page 63 to copy the configuration file
to additional 460 Gateways.
Creatingaconfigurationfile
If the 460 Gateway is already connected to a personal computer and can access the Real Time
Automation web site (factory set at http://192.168.0.100), skip to step 5.
1. Connect one end of an Ethernet crossover cable to the 460 Gateway and the other end to
the RJ45 connector on your computer. A red Ethernet crossover cable was shipped with
the 460 Gateway.
2. Insert the power connector to the 460 Gateway and then plug the power cord into a power
source.
eway and then plug the power cord into a power
source.
3. Your computer needs to be on the same subnet as this 460 Gateway unit. The unit’s
default IP address is 192.168.0.100. Therefore your computer’s IP address must be set at
192.168.0.xxx, where xxx is any number that is not being used by any other device on
your network.
If your computer is using a dynamic IP address (typical), you need to change it to a static
192.168.0.xxx address. Use the following steps to change your computer’s IP address.
3. Your computer needs to be on the same subnet as this 460 Gateway unit. The unit’s
default IP address is 192.168.0.100. Therefore your computer’s IP address must be set at
192.168.0.xxx, where xxx is any number that is not being used by any other device on
your network.
If your computer is using a dynamic IP address (typical), you need to change it to a static
192.168.0.xxx address. Use the following steps to change your computer’s IP address.
a. Go into your Network Setup. a. Go into your Network Setup.
b. Select
Internet Protocol (TCP/IP). b. Select Internet Protocol (TCP/IP).
460 Gateway User Manual Page 60