User manual

Default IP Address – 192.168.0.100
Connecting cables
Once the jumpers are set for the correct serial interfaces and the configuration and network
settings are selected, you only need to connect the communications cables and attach the power
cable, before verifying that data is transmitting correctly. Use the following steps to connect the
appropriate cables.
1. Mount the 460 Gateway in the desired location.
2. Connect the appropriate cable to Port 0 on the 460 Gateway and the other end to the
device that matches the protocol selected for Port 0. Do the same for Port 1. Use the
correct cables.
3. If you are connecting the 460 Gateway to a network, plug one end of a non-crossover
Ethernet cable (RJ45) to the front of the 460 Gateway. Plug the other end into the
network/switch/hub.
Note: In order to view the status of the data communications between the devices
connected to the 460 Gateway via the Gateway’s utilities, the 460 Gateway must be
connected to a network (or computer).
4. Plug the power connector into the front of the 460 Gateway. Plug the other end of the
power cord into a power supply.
You have completed installing the 460 Gateway.
460 Gateway User Manual Page 54