User manual

Default IP Address – 192.168.0.100

Step

Figure 2-66 Network Setup screen

2. Enter the IP address that identifies the 460 Gateway to the network.

3. Enter the subnet mask that identifies which devices can communicate with the 460

Gateway.

4. Enter the default gateway to use if the device cannot be accessed directly.

5. When you are finished entering these values, click on Store Parameters.

The 460 Gateway Main web page displays.

Note: The

Restore original values button causes the parameters to display that were entered

when the page loaded.

6. When you have finished making any desired changes to the 460 Gateway’s configuration,

continue with the following section, Making Settings Take Effect.

For Your Information: If you need to configure more than one 460 Gateway with

the same or similar settings, it may be quicker to configure the first gateway

using these directions and then save the configuration to a file to use for the

other gateway units.

Note that for gateways that are configured from a file, you still need to set

jumpers (if desired), edit the network settings, and restart the gateway to make

the settings take effect. See Configuring 460 Gateways from a file on page 60

for more information.

460 Gateway User Manual Page 51