User manual

En
11
3. Press the OK button to view the satellite list and then select the satellite you want to add.
4. Press the OK button to conrm your selection.
5. You should not need to set any of the following items in the Dish Settings menu as they should all be pre-
xed to the default values (highlighted below).
The settings will only need to be changed if a motorized system is used or a DiSEqC switch is used to
select one from multiple LNB feeds.
LNB Power:• [13V/18V] Set LNB power 13V/18V with the ◄►buttons.
• LNB Type: [9750/10600] Set LNB type with the OK button. Select User Single or User Dual to
input LO frequency values manually.
Low Band: [9750] Can be input with the remote control numeric keys.
High Band: [10600] Can be input with the remote control numeric keys.
• 22 kHz: [Auto] Set the path of 0/22kHz band switching control signal to On, Off or Auto mode.
• DiSEqC1.0/1.1: [LNB1] Set the assigned port on the DiSEqC switch or monoblock LNB.
6. Press the Green button and enter text characters if you wish to change a satellite name. Press the EXIT
button to leave this menu.
3. INSTALLATION - MOTORIZED DISH SETTING
You need to position your antenna correctly for receiving the best signal quality. Consider also consulting the user
manual supplied with your DiSEqC/USALS motor.
1. Select Motorized Dish using the ▲▼ buttons and press the OK button.
2. Select the satellite using the ◄► buttons or press OK to select a satellite from the satellite list by using the
▲▼ buttons. The Motorized Dish Setting menu indicates the selected satellites.