Installation Manual
11
INSTALLATION MANUAL
3. XTO-IP PANEL PROGRAMMING
XTO-IP Alarm panel
SERVER
ADDRESSES ?
The IP1 address, Domain name 1 and/or Port 1 are provided by the monitoring station.
Leave Port details at 888 unless otherwise instructed.
Press
OK
or
YES
to enter/modify the parameter then
OK
or
YES
for validation.
WARNING : You will use either an IP address or a Domain name but not both, leave the
Domain name blank if an IP address has already been entered.
Press on the right arrow to configure IP/Domain name 2 and PORT2 (for the back-up server),
and IP/Domain name TMT and PORT TMT (to configure remote maintenance server).
ESC
NO
OK or YES
ESC
NO
STR ATEGY:
ETH+2G3G4G
2G3G4G
PARAMETERS ?
ESC
NO
OK or YES
TEST IN PROGRESS
END = OK/YES
2G3G4G LEVEL
5/5
2G3G4G LEVEL ?
2G3G4G LEVEL ?
OK or YES
The APN Code (Access Point Name), User Name an
d Password are supplied by the
mobile operator. Please make sure you have entered the code exactly as indicated by your
local SIM card operator.
Press
OK
or
YES
to enter/modify the parameter then
OK
or
YES
for validation.
Note: When entering your SIM card settings, both APN codes, username and
password fields are case sensitive! It makes a difference between UPPER and lower
case letters.
To switch between UPPER and lower case, use the M/m key from CMA keypad or hold a digit key
(0-9) for XMA/XMB.
Once the 2G3G4G test completed, the keypad will display one of the following results :
- A level between 0/5 and 5/5.
- A GPRS Error code (please see Chapter 7 : 2G3G4G errors codes and contact your
technical support).
If the screens shuts down, press any key to light it up except
OK
or
YES
,
ESC NO
or
CLR
.
The 2G3G4G level test can last several minutes. Do not interrupt the test or remove the SIM
card during the test.
IM
PORTANT : Videofied will require a 3/5 grade or better for reliable transmission
of Video alarms.
ESC
NO
2G3G4G
PARAMETERS ?
OK or YES
How the alarms and videos are transmitted to the monitoring station ?
ETH+2G3G4G : Ethernet transmission with GPRS backup.
2G3G4G : GPRS transmission only (if the Ethernet connection is not used).
ET
H : Ethernet transmission only (only if GPRS is not used).
Warning : the transmission mode “Ethernet only” is not recommended.
ESC
NO
IP1 ADDRESS
0.0.0.0
DOMAIN NAME 1
PORT 1
888
APN CODE
internet-entrepr
USER NAME
orange
PASSWORD
orange