User Manual

4
INSTALLATION MANUAL
1. XTO-IP PANEL SETUP
XTO-IP Alarm panel
1.3 Panel bracket mounting
The four screwholes here opposite are intended to
mount the bracket, the latter beeing used to attach
the panel to the wall or a pole.
Mounting the panel is not required for programming.
Screwholes
1.2 RJ45 cable connection
Connect the RJ45 cable to the Ethernet port.
When the panel attempts a transmission via Ethernet, a red LED on the connector will flash. This will allow the installer
to check whether the panel is connected to a valid network.
Do not touch the RJ45 cable when the panel is powered.
1.1 SIM card installation
Before removing the front cover from its box, Put the SIM
card on the plastic base (Take care to respect the right
direction).
DO NOT insert or remove the SIM card while the panel is
powered.