User Manual

12
INSTALLATION MANUAL
3. XTO-IP PANEL PROGRAMMING
XTO-IP Alarm panel
IP
PARAMETERS ?
OK or YES
ETHERNET parameters configuration
DHCP :
ENABLED
PANEL IP
DHCP :
DISABLED
OK or YES
IP MASK
GATEWAY
PRIMARY
DNS
SECONDARY
DNS
IP
PARAMETERS ?
ESC
NO
ETH. STATUS?
TEST IN PROGRESS
END = OK/YES
ESC
NO
OK or YES
PANEL IP
XXX.XXX.XXX.XXX
ETH. STATUS?
ESC
NO
ESC
NO
During this test, the panel tries to connect to
the local Ethernet Network. The result of this
test can be:
• If the connection is successful: the local
IP of the panel will be displayed (you
can display other Ethernet parameters
with the arrows ).
• ETHERNET OFF NO STATUS : the
Ethernet module is switched off. Please
verify that the Ethernet cable is connected
and try again.
• NETWORK/CABLE MISSNG : the
panel doesn’t detect Ethernet Cable or
Network.
By setting the DHCP as
ENABLED, a new IP address will
be assigned dynamically to the
panel every time it connects
to the network. Network
parameters will not be asked.
If the router forces a static IP
address for the panel, there will
then be a need to define DHCP
as DISABLED. You will then need
to fill in the following network
parameters fields : Panel IP, IP
Mask, Primary DNS, Gateway
and Secondary DNS.
Warning: Verify that the IP
address selected is available on
the Network and accepted by
the router.
OK or YES