User's Manual
Table Of Contents
- Table of Contents
- Introduction:
- In order for an installation to be UL compliant you must follow the specifications in the table below:
- XT Initial Programming
- XT-IP620 Programming
- Device Installation
- Entering a Badge or Access Code for Arming/Disarming
- Configuration of Special Arming Modes:
- How to Disable/Enable Monitoring
- ETHERNET Parameters:
- How to test to the dispatch center
- How to Disable Monitoring
- How to test RF for deployment of devices
- XT-IP620 Power Chart
- Arming Input Wiring Diagram
- How to test to the dispatch center
- How to mount the XT-IP620
- Troubleshooting
- Monitoring Station is not getting ANY video but is getting signals:
- Monitoring Station is not getting any signals:
- Panel is staying CONNECTED WITH MONITOR STATION
- Unable to record device or getting ‘Pairing Failure’ error
- Outdoor MotionViewer Trips All the Time:
- XT-IP620 -SERIES ‘AFTER INITIAL PROGRAMMING’ FLOW CHART
- 1. LSH20 Control Panel Batteries:
- 2. LS14500 Peripheral Batteries: Excludes SE601 and SE651
- 3. Lithium Battery Storage:
- 4. Finding Manufacture Week and Year:
- 5. Event Log Ethernet Codes
- 6. Additional System Codes
- 7. Replacing Device and Control Panel batteries
- 8. Checking control panel firmware version
2012/1/9 Ed 1.1 Setup and Programming manual for XT-IP620 series
2 | Page
Table of Contents
Page
FCC 3
Installation Guidelines 4
Introduction 5
Initial Programming 6-15
Device Installation 16
Entering Badges and Access Codes 17-18
Choosing Siren Options 18
Disabling Monitoring 19
Ethernet Parameters and Testing 20
Testing Device RF Level 21
XTIP Power Chart 22
Arming Input Wiring Diagram 23
Testing to Central Station 24
Mounting Control Panel 25
Troubleshooting 26-28
After Initial Programming Flow Chart 29-30
Addendum 31-33
Battery Specifications 31
Finding Manufacture Week/Year 32
Event Log Ethernet Codes 32
Additional System Quick Codes 32
Replacing Device and Control Panel batteries 33
Checking Control Panel Firmware 33