User's Manual
Table Of Contents
- Table of Contents
- Introduction:
- In order for an installation to be UL compliant you must follow the specifications in the table below:
- XT Initial Programming
- XT-IP620 Programming
- Device Installation
- Entering a Badge or Access Code for Arming/Disarming
- Configuration of Special Arming Modes:
- How to Disable/Enable Monitoring
- ETHERNET Parameters:
- How to test to the dispatch center
- How to Disable Monitoring
- How to test RF for deployment of devices
- XT-IP620 Power Chart
- Arming Input Wiring Diagram
- How to test to the dispatch center
- How to mount the XT-IP620
- Troubleshooting
- Monitoring Station is not getting ANY video but is getting signals:
- Monitoring Station is not getting any signals:
- Panel is staying CONNECTED WITH MONITOR STATION
- Unable to record device or getting ‘Pairing Failure’ error
- Outdoor MotionViewer Trips All the Time:
- XT-IP620 -SERIES ‘AFTER INITIAL PROGRAMMING’ FLOW CHART
- 1. LSH20 Control Panel Batteries:
- 2. LS14500 Peripheral Batteries: Excludes SE601 and SE651
- 3. Lithium Battery Storage:
- 4. Finding Manufacture Week and Year:
- 5. Event Log Ethernet Codes
- 6. Additional System Codes
- 7. Replacing Device and Control Panel batteries
- 8. Checking control panel firmware version
2012/1/9 Ed 1.1 Setup and Programming manual for XT-IP620 series
13 | Page
ETHERNET
PARAMETERS
PANEL IP
IP MASK
ETHERNET
PARAMETERS?
PRIMARY DNS
SECONDARY DNS
GATEWAY
ENABLE
DISABLE
• These parameters are not necessary if you choose
DHCP ENABLE
• These parameters are the local network parameters.
It’s necessary to configure all these parameters if
DHCP is disabled.
IMPORTANT: Verify that the IP address selected is
available on the Network.
ETH. STATUS?
ESC/NO
YES/OK
TEST IN PROGRESS
OK/YES/OK = END
PANEL IP
xxx.xxx.xxx.xxx
ETH. STATUS?
During this test, the panel tries to connect to the local
Ethernet Network. The result of this test can be:
• If the connection is successful: the local
IP of the panel will be displayed (with right
arrow you can display other Ethernet
parameters – IP Mask, primary & secondary,
Gateway).
• ETHERNET OFF NO STATUS: the Ethernet
module is switched off. Please verify that the
Ethernet cable is connected and try again.
• CABLE OR NETWORK ABSENT: the panel
doesn’t detect Ethernet Cable or Network.
• DHCP ERROR: the panel is not able to get
an IP from the DHCP. DHCP may be
enabled but the network may not have a
DHCP lease available.
DHCP:
ENABLE OR DISABLE
ESC/NO