User Manual

2013/01/18 Ed 1 Setup and Programming manual for XTIP series
13 | Page
1375 Willow Lake Blvd. #103
Vadnais Heights, MN 55110
©YES
/OK
Ö
Ö
Ö
Ö
Ö
ESC/NO
©YES/OK
©YES/OK
2G3G
PARAMETERS ?
APN CODE
APN CODE:
xxxxx.xxxxxx.xx
Your APN code (Access Point Name) is given to you by your
Cellular Provider. Press ©YES/OK to enter into the
parameter and use the Keypad to complete the code. Press
©YES/OK to confirm your entry and the Öarrow to move
to the next parameter.
USERNAME
PASSWORD
Your USERNAME is given to you by your Cellular Provider.
Press ©YES/OK to enter into the parameter and use the
Keypad to complete the name. Press
©YES/OK to
confirm your entry and the
Öarrow to move to the next
parameter.
PASSWORD:
xxxxxxxxxxxx
USERNAME:
xxxxxxxxxxx
©YES/OK
©YES/OK
©YES/OK
Your PASSWORD is given to you by your Cellular Provider.
Press ©YES/OK to enter into the parameter and use the
Keypad to complete the name. Press
©YES/OK to
confirm your entry and ESC/NO followed by ESC/NO again
to get back to programming.
©YES/OK
STRATEGY
ETH+2G3G
STRATEGY:
ETH
STRATEGY:
2G3G
Press right arrow
Ö
to select the transmission mode for
alarms and videos and YES/OK to confirm.
1. Ethernet transmission with 2G3G back-up
2. Ethernet transmission only
3. 2G3G transmission only
Warning: the transmission mode “Ethernet only” is not
recommended.
Ö
Ö
2G3G LEVEL?
TEST IN
PROGRESS
2G3G LEVEL
x/5
©YES/OK
During the 2G3G Level test the Modem will boot and
attempt to gain access to the cellular network. The system
will display either a signal level out of 5 or an error code.
Error codes are listed in the troubleshooting section. To
keep the keypad awake, use any key on the keypad except
the YES/OK, ESC/NO, and CLR keys. This test can take
up to 5 minutes. Once the level or error has posted press
YES/OK to continue in programming.
*For explanation of 2G3G errors see bottom of page 16.
Videofied will require a 3/5 or better for reliable transmission
of Video alarms
©YES/OK
2G3G
PARAMETERS ?
©YES/OK