User Manual

2013/01/18 Ed 1 Setup and Programming manual for XTIP series
12 | Page
1375 Willow Lake Blvd. #103
Vadnais Heights, MN 55110
SERVER
ADDRESSES?
CODE/STATE
MODIFICATION?
SERVER
ADDRESSES?
CODE/STATE modification
These are the default transmitted events:
Device Alarm
Alert Alarm
Initialization Not Transmitted
Panel Batteries Alarm/End
AC Power Alarm/End
Phoneline Fault Not Transmitted
Tamper Alarm/End
Device Batt. Alarm/End
Radio Jamming Not Transmitted
Supervision Alarm/End
Periodic Test Alarm
Wrong Codes Not Transmitted
Duress Code Alarm
Alarm Memory Not Transmitted
Arm/Disarm Not Transmitted
Fire Alarm
Medical Assist Alarm
Ethernet Alarm/End
If you would like to change the state
press
©YES/OK and use the Õ or Öto toggle
between:
Alarm – Appearance
Alarm/End – Appearance and Restoral
Not Transmitted – Not Transmitted
TRANS. STATE
MODIFICATION
List of all
events
©YES/OK
ESC/NO
©ESC/NO
TRANS. STATE
MODIFICATION
©YES/OK
ESC/NO
IP 1 ADDRESS
IP1 ADDRESS:
xxx.xxx.xxx.xxx
©YES/OK
©YES/OK
DOMAIN NAME 1
DOMAIN NAME 1:
xxxxx.xxx.xxx
©YES/O
PORT 1
PORT 1:
xxx
©YES/OK
©YES/OK
©YES/OK
ESC/NO
ESC/NO
Your IP1 address is given to you by your Central Station.
Press ©YES/OK to enter into the parameter and use the
Keypad to complete the address. Press
©YES/OK to
confirm your entry and the
Öarrow to move to the next
parameter. *You will use either an IP address or a Domain
Name but not both
*When entering an IP address you must enter all 12 digits
including preceding zeros.
Your Domain Name is given to you by your Central Station.
Press ©YES/OK to enter into the parameter and use the
Keypad to complete the name. Press
©YES/OK to
confirm your entry and the
Öarrow to move to the next
parameter. *You will use either an IP address or a Domain
Name but not both leave it blank if an IP has already been
The Port is given to you by your Central Station. By default
the panel will use 888. If you need to modify the port press
the
©YES/OK key to enter into the parameter and the
keypad to complete the port. Press
©YES/OK to confirm
and the Öarrow to move to the next parameter.
Continue through IP2 and TMT IP.
Once you have entered all valid parameters press ESC/NO
to return to the main menu then ESC/NO again to move to
the next parameter.
Your IP1 address is given to you by your Central Station.
Press ©YES/OK to enter into the parameter and use the
Keypad to complete the address. Press
©YES/OK to
confirm your entry and the
Öarrow to move to the next
parameter. *You will use either an IP address or a Domain
Name but not both
*When entering an IP address you must enter all 12 digits
including preceding zeros.
Ö
Ö