Installation Manual

2013/01/18 Ed 1 Setup and Programming manual for XTIP series
20 | P a g e
1375 Willow Lake Blvd. #103
Vadnais Heights, MN 55110
Access level
Definition & rights
LVL1
Stand by level
LVL2
Restricted USER level where it is only possible to arm/disarm the system.
LVL3
USER level where it is possible to arm/disarm the system, check the event
log, test the devices.
Modifications of the setting are not possible at this level.
User LVL3 can create LVL3 or LVL2 access codes.
LVL4
INSTALLER level where it is possible to modify the setup of the panel. The approval of a
LVL3 or LVL2 is required to modify the level for LVL4.
Installer LVL4 can create the first LVL3 access code only.
Configuration of Special Arming Modes:
A
Armed
D
Disarmed
P
Perimeter Devices Only
(devices must be programmed)
E
External Devices Only
(devices must be programmed)
Siren
Immediate triggering of all sirens
Delay beeps
Entry/Exit delay beeps, then triggering of the sirens
Silent
No Sirens, No Beeps
Without Siren
Beeps on the keypad only
To configure or modify a special arming mode, with the direction arrow go to the menu:
CONFIGURATION (LEVEL 4) + [YES/OK] ALARM MODES PROGRAMMABLE + [YES/OK]
FULLY ARMED, SP1 and SP2 (use direction arrows to select the arming mode you want to
modify + [YES/OK]).
For each arming mode, it is possible to specify how each of the 4 areas will be armed and how
the system will behave during an alarm.
Areas: 1 2 3 4 press the corresponding number to change that areas arming option
States: A A A A state for the respective area.
Press the [YES/OK] key after this configuration step. The system will then display what siren
mode will be in effect for this special profile. Select the siren mode using the direction arrows
then press [YES/OK].