Installation Manual

2013/01/18 Ed 1 Setup and Programming manual for XTIP series
18 | P a g e
1375 Willow Lake Blvd. #103
Vadnais Heights, MN 55110
How to Disable/Enable Monitoring
Disabling monitoring can be a useful tool in many situations. Before mounting devices and moving the
panel to find a good GPRS / 3G level, disabling monitoring will ensure that you will have access to
programming and that unnecessary signals are not sent to the monitoring station. When performing
maintenance on the system disabling monitoring until the issue has been resolved will ensure that you will
have access to programming throughout your troubleshooting.
Use the

to move to CONFIGURATION MONITOR.
STATION
Press YES/OK on MONITORING ENABLED and use the

to change the value to DISABLED and press YES/OK
to lock it in. Press and hold ESC/NO for 5 seconds to return
to the main menu.
Press YES/OK on MONITORING PARAMETERS
Press the  to move to CONFIGURATION
Enter the installer code for the system. If a level 3 code is
entered in the system you will be required to authenticate with
that code as well.
Press the arrow to move to ACCESS LVL.
Use your arrow keys to change the level to 4
YES/OK
MONITORING:
DISABLED
YES/OK
YES/OK
GENERAL
PARAMETERS
YES/OK
YES/OK
BADGE OR CODE
****
YES/OK
CONFIGURATION
MONITOR.
STATION
ACCESS LVL: 4
MONITORING
PARAMETERS
MONITORING
ENABLED
CONFIGURATION
ACCESS LEVEL
1
10/12/27 10:53
DISARMED LVL:1