Installation Manual

2013/01/18 Ed 1 Setup and Programming manual for XTIP series
14 | P a g e
1375 Willow Lake Blvd. #103
Vadnais Heights, MN 55110
ETHERNET
PARAMETERS
PANEL IP
IP MASK
ETHERNET
PARAMETERS?
PRIMARY DNS
SECONDARY DNS
GATEWAY
ENABLE
DISABLE
• These parameters are not necessary if you choose
DHCP ENABLE
• These parameters are the local network parameters.
It’s necessary to configure all these parameters if
DHCP is disabled.
IMPORTANT: Verify that the IP address selected is
available on the Network.
ETH. STATUS?
ESC/NO
YES/OK
TEST IN
PROGRESS
OK/YES/OK = END
PANEL IP
xxx.xxx.xxx.xxx
ETH. STATUS?
During this test, the panel tries to connect to the local
Ethernet Network. The result of this test can be:
 If the connection is successful: the local
IP of the panel will be displayed (with right
arrow you can display other Ethernet
parameters – IP Mask, primary & secondary,
Gateway).
 ETHERNET OFF NO STATUS: the Ethernet
module is switched off. Please verify that the
Ethernet cable is connected and try again.
 CABLE OR NETWORK ABSENT: the
panel doesn’t detect Ethernet Cable or
Network.
 DHCP ERROR: the panel is not able to get
an IP from the DHCP. DHCP may be
enabled but the network may not have a
DHCP lease available.
DHCP:
ENABLE OR DISABLE
OU INACTIF
ESC/NO