Installation Manual

2011/11/10 Ed 1.5 Setup and Programming manual for XT series GPRS
5 | P a g e
4455 White Bear Parkway, Suite 700
White Bear Lake, MN 55110
Introduction:
Description:
The XT series control panel is a Videofied wireless, battery operated hybrid alarm system.
It is designed for residential, small business and commercial security applications. The XT
provides integrated Video Verification over GPRS.
The XT has programmable inputs and outputs. XT also features mapping where an
external input can be used to generate a video clip from a MotionViewer.
Internal RF range and GPRS range can be enhanced using external antennas.
Supervised Wireless Technology:
The XT, along with all Videofied devices, uses the patented S2View® - Spread Spectrum,
Videofied, Interactive, AES Encrypted Wireless technology, providing optimum
signal integrity and security.
The bi-directional RF communication path between all devices and the system control
panel guarantees high signal reliability. Integrated antennas eliminate protruding wires or
rods, which are difficult to install, unsightly to consumers and potentially troublesome if
damaged.
The panel supervises every device (excluding the remote key fob) to validate current
open/close state, tamper condition, serial number, date of manufacture, firmware revision,
and battery status.
Type
Specifications
Location In Manual
Audio
When a MotionViewer is
installed on the system you
may not have the siren sound
for less than 60 seconds
Page 26
Audio
If no MotionViewer is installed
on the system you may not
have the siren sound for less
than 240 seconds
Page 26
Delays
When a MotionViewer is
installed on the system the
Entry delay must be 45 seconds
Page 9
In order for an installation to be UL compliant you must follow the
specifications in the table below: