Installation Manual

2011/11/10 Ed 1.5 Setup and Programming manual for XT series GPRS
13 | P a g e
4455 White Bear Parkway, Suite 700
White Bear Lake, MN 55110
YES





ARMING OPTION :
From The Host
MODE:
Slow
MODE:
Fast
Mode Slow : Used for following the arming and disarming of
the host system. This will arm each device one at a time
conserving battery life.
Mode Fast : Used to instant arm all devices while sacrificing
battery life.
ENTRY DELAY
Enter the value for your Entry Delay up to 255 seconds and
press YES.
VALUE:(0-255)
(000):

TRANSMISSION
DELAY
Value: (0-600)
(000):
ARMING
CONFIRMATION
YES
Value: (0-240)
(0):
YES
YES
YES
YES
By entering a value using the keypad, up to 600 seconds,
the transmission of any event will be delayed that many
seconds.
Enter the value you would like for the Transmission Delay
and press YES
Arming Confirmation is the number of seconds of latched
voltage (where voltage must stayed latched after) the panel
will require before arming. This will be considered your exit
delay.
Enter the value you would like for the Arming Confirmation
and press YES
YES
Using the control panel as a Xtender system will only be able to arm and disarm by latching 9-12v to
one of the two inputs.
Arming input 1 will control the arming and disarming of devices in areas 1 and 2. Where devices in
area 1 are subject to the Entry Delay.
Arming input 2 will control the arming and disarming of devices in areas 3 and 4. Where devices in
area 3 are subject to the Entry Delay.