Installation Manual

2011/11/10 Ed 1.5 Setup and Programming manual for XT series GPRS
12 | P a g e
4455 White Bear Parkway, Suite 700
White Bear Lake, MN 55110
CODE/STATE
MODIFICATION ?
AREAS
CONFIGURATION
AREA NAME 1:
Other values are available:
2 min, 1 min, 45 sec
Use the arrows for the selection and YES to confirm.
Other values are available:
2 min, 1 min, 45 sec, 30 sec, 15 sec
Use the arrows for the selection and YES to confirm.
Use the Alphanumeric Keypad to name the area and press
YES. Repeat for all four areas. If you want to keep the
default area names press the ESC/NO key.
By default Area 1 is a delay area and Area 2, 3, & 4 are
instant areas.
CODE/STATE modification
These are the default transmitted events:
Device Alarm
Alert Alarm
Initialization Not Transmitted
Panel Batteries Alarm/End
AC Power Alarm/End
Phoneline Fault Not Transmitted
Tamper Alarm/End
Device Batt. Alarm/End
Radio Jamming Not Transmitted
Supervision Alarm/End
Periodic Test Alarm
Wrong Codes Not Transmitted
Duress Code Alarm
Alarm Memory Not Transmitted
Arm/Disarm Not Transmitted
If you would like to change the state
press YES and use the  or to toggle
between:
Alarm – Appearance
Alarm/End – Appearance and Restoral
Not Transmitted – Not Transmitted
If you would like the default press ESC/NO
Wait
TRANS. STATE
MODIFICATION
List of all
events
YES
ESC/NO
ESC/NO
EXIT DELAY:
45 Sec
ENTRY DELAY:
15 Sec
ARMING OPTION:
From the host
ARMING OPTION:
Standalone
ARMING OPTION: Your choice will depend on how you are
arming the system.
From the host: Will make the XT a piggyback/xtender
system that arms and disarms off the latching of 9-12v on
the arming inputs.
Standalone: Will make the XT a solo system controlled by
arming and disarming using Videofied peripheral devices.

Go to Page 10 if you
will be choosing this
option
Go to Page 11 to continue
with standalone programming