User's Manual

On a piece of paper :
• Name the 4 geographical zones
A geographical zone corresponds to a surface where all the
sensors are armed/disarmed together. A partial arming prole is
a combination of geographical zones which are either armed or
not. By using the examples below, you are going to meet most
of the requirements.
Area
A magazine Area A person
1 ENTRY DELAY 1 ENTRY DELAY
2 MAGAZINE 2 RDC
3 STOCK 3 FLOOR or OFFICE
4 DISCOUNT 4 GARAGE
(The1st geographical zone is inevitably delayed)
• Name the devices
Be as explicite as possible because in case of intrusion, it is this
device’s name that will display on the keypad and transmit to the
monitoring station. Example : CAM HALL ENTRANCE (for a
camera at the entrance).
• Allocate a geographical zone (from 1 to 4) to each
device.
1. Preparation before programming
2. The golden rules
1
The area 1 is always delayed.
2
Never place the panel near an electric switchboard :
there is possible interference with the radio and GPRS
modem.
3
Place the alarm panel at the most central location of the
site to be protected (also garantees a better propagation of
the radio).
4
When there is typing error, use the to delete the
incorrect character.
5
Never record the same device twice without
having rst deleted the device off of the panel.
6
Record a maximum of 19 devices of any kinds, without
distinction (initial keypad included).
7
Respect the installation height (under device) of
PIR : 2m10 to 2m35, cameras MotionViewer : 2m10 to
2m35 (ideally in an unobstructed angle)
8
Respect the installation height (under device) of
MotionViewer and PIR pet immune : 2m10.
9
Installation height for external DCV cameras: 2m80 to 3m
using the MB ball-and-socket joint (optional) and angling
the camera at the target to be protected.
10
If you are using a remote keypad, don’t install it at the
beginning of the installation
Always clean the camera’s lens after installation
(with a clean and dry piece of cloth, without pressing
on the lens).
12
To change from Capital to lower case, rst press the ,
then change from small letter/capital letter with and vice-
versa.
13
Be careful when opening and closing the panel cover (its
components are fragile).
• Dene the partial arming proles (combinations of
areas, see paragraph 5 and the partial programs on page 7).
• Ask the end user to prepare his/her codes (18
maximum access codes with 4 to 6 numbers per code).
11