User's Manual

00
EMEA SALES
23, avenue du ral Leclerc
92340 BOURG-LA-REINE
FRANCE
Hot line : +33 (0)820 846 620
Fax : +33 (0)3 90 20 66 36
© 2009 RSI Video Technologies Videoed® is a Registered Trademark of RSI Video Technologies.
Specications subject to change without notice.
www.videofied.com
North American Headquarters
4455 White Bear Parkway, Suite 700
White Bear Lake, MN 55110
USA
Hot Line : 877-206-5800
Fax : 651-762-4693
8. Numeric Keypad
Symbols Explanations
D
When the indicator light is green: indicates that all the batteries (panel + peripheral) are OK
• When the indicator light is red: indicates that there is a battery fault either on the panel or on
a peripheral device (the will be indicated on the display)
P
During arming: signals the detection of a peripheral device in a zone not on a time setting
Not armed: signals the auto-protection of a peripheral device (the will be indicated on
the display)
Used in order to identify:
of the peripheral device (0 for the panel and 1 to 19 for the peripheral devices) in the vent
of auto-protection, intrusion, low battery, etc.
Incorrect authentication (‘C’ for wrong code)
Indicates that there has been an intrusion
Indicates any other fault (radio interference, ect.)
Symbols Explanations
D
Used to disarm the system (after entering the code)
P
Enables arming in partial mode (after entering the code)
Flashes when the system is partially armed
Enables arming in total mode (after entering the code)
Flashes when the system is totally armed
Enables arming in total mode (after entering the code)
Symbols Explanations
D
Key to be held down for 3 seconds to activate panic buttons
P Once it lights up, pressing this key will send a police call through to the monitoring station
Once it lights up, pressing this key will send an emergency call through to the operators
Once it lights up, pressing this key will send an emergency call through to the operators
This key allows you to cancel the activation of the panic buttons
Symbols Explanations
à D
Keys for entering user codes
P Key for conrming code
Delete key in case off error
Using the numeric keypad: to conserve the batteries, the numerical keypad automatically turns off after a few seconds of not being used. Before entering
the code, you need to reactivate it. To do so, place your hand at over the numeric keypad, it will light up and then you can use it.