User's Manual
6. Details of the menu : ALARM CODE
Signalling events by default (except if you are
using pre programming)
By default these events are transmited:
DEVICE (intrusions)
ALERT (button)
TAMPER
PERIODIC TEST
By default are not transmited:
INITIALIZATION
PANEL BATTERIES (low panel batteries)
AC POWER (panel power off)
PHONELINE FAULT (telephone)
DEVICE BATT. (low batteries devices)
RADIO JAMMING (radio jamming)
SUPERVISION (default supervision)
WRONG CODES (when entering 5 false codes/badges)
DURESS CODE (panic button)
ALARM MEMORY (old memory overwritten)
ARM/DISARM (open/close)
There are the 3 transmission
states:
ALARM, which can be heard :
when it appears
ALARM / END, which can be
heard : when it appears and disap-
pears
NOT TRANSMITTED
Examples :
- If one wishes to recall events of ARMING/DISARMING (operate/stop), you will have to modify the
conguration of events ARMING/DISARMING to ALARM / END.
- If you wish to recall the false codes information, you will have to modify the conguration of events
WRONG CODES on the state ALARM.
How to modify the transmission state of events?
2 possible solutions:
• At installation, just after having validated the hour of the cyclic test, the keypad requests :
CODE/STATE
MODIFICATION ?
• After the initial installation, by using the keypad :
With direction arrows go to the menu CONFIGURATION (level 4) -> CONFIGURATION MONITOR. STATION
-> ALARM CODES -> TRANS. STATE MODIFICATION
Then:
With direction arrows Select the event to transmit, make then modify the transmission state with arrows
and revalidate with the [YES] key. Renew the operation for each event which you wish to modify the transmission regulations.
Press on the to access the menu TRANS. STATE MODIFICATION
In all cases, be sure to check that the conguration of your XL
system is suitable for your needs.