Installation Instructions

www.videofied.com
Mounting
>
Use proper tools and hardware.
>
Mount where siren can be heard by occupants.
>
Mount out-of-reach of intruders to help prevent
disabling of unit.
1
Remove batteries.
2
Hold unit up
against mounting
surface and mark
the three mounting
holes.
3
Drill pilot holes
and install anchors
where needed.
4
Place unit on mounting surface so mounting holes
line up with pilot holes/anchors and secure unit with
appropriate screws.
5
Install batteries, observing correct polarity.
6
Attach front cover.
Electrical Data
Panel Compatibility XL, Visio, XT, XTIP
Power requirements Four 1.5 V Alkaline Batteries
Nominal Voltage 6V
Low Battery Limit 4.2V
Battery type Energizer Alkaline LR20, D size
Battery life Up to 4 years
RF technology S
2
View
®
Radio type Spread Spectrum Bidirectional
Operating frequency 915 MHz
Transmission security AES encryption algorithm
Supervision Polled signal every 8 minutes
Antenna Integrated
Tamper detection Wall and cover tampered
Speaker impedance 4 ohms
Output level 110 dB @ 1 meter
Output duration Configured in Control Panel
Built-in sounder Emits entry/exit delay beeps, alarms
Operating temperature -10°/+40°C (14°/104°F)
Maximum relative humidity 70%, non-condensing
Approvals FCC Part 15C
Physical Data
Material ABS—ULV0
Dimensions (LxWxD) 280 mm x 158 mm x 57 mm
11 in. x 6-1/4 in. x 2-1/4 in.
Weight 740 g/26 oz.(without batteries)
Installation/Mounting
Siren/Base Two screws secure siren to base; three screws
secure siren base to mounting surface.
Mounting Holes
Indoor Siren SE601
INSTALLATION DATA SHEET