User Manual

The OMV 210/611/712 MotionViewer is a wireless, battery
operated, motion activated or electrically activated outdoor
camera designed for use in Videofied
®
security systems.
• Powered by 4 Lithium batteries for extended battery life.
• 90° wide lens (by default).
• Provided optional lenses: vertical and horizontal curtain, long
range beam (up to 18m).
• 4 infrared LEDs for 12m night vision.
• Standard detection distance (up to 12 meters).
• Fully weatherproof (IP65) and temperature resistant
(-20°C/+60°C).
• Tilt sensor tamper.
• Transmits check-in/status signal every 8 minutes.
• 3 wired programmable inputs (2 supervised).
• 1 wired programmable output triggered on detection.
Product Summary
Installation Guidelines
For easier installation, programming and RF testing should be done to check for
good communication between the control panel and all system devices before
mounting system devices.
Install the detector and other system devices in the order of the following steps:
>
Programming/RF Testing - program detector and all other devices into the
control panel and test RF communication from each intended device location to
the control panel.
>
Mounting - mount detector at the tested location.
Mounting
>
Use proper tools and hardware.
>
Mount camera between 2.5 m to 4 m height.
>
The OMV MotionViewer detection distance may vary depending on weather
and the detector mounting (height, tilt). The OMV is not suitable to protect an
area, it needs to be used to protect an access point or any property.
>
Mount detector aimed toward the spot to protect.
>
In order to reduce false alarms, do not aim the detector toward vegetation, a
road, or unlimited space.
>
Do not cover the Fresnel lens. Use only the provided masking kit to block
detection towards specific spots (trees, bushes, etc.).
MB110 Mounting kit for
Outdoor MotionViewer
DOC. - REF. 213-OMV
VERSION : JULY 2015
1
INSTALL SHEET
OMV OUTDOOR MOTION VIEWER