Installation Instructions

During arming
The arming stops.
The two indicators ash green
for 5s then turn off: A fault was
detected.
In order to know more about
what happened a keypad is
required.
Without action from the user,
arming will start again after 3
min and the concerned detector
will be bypassed from this
arming.
Flashing of the top red
indicator (only) every second
during arming delay.
The top red indicator
ashes every two seconds
indicating that the system is
armed.
Everything is ne :
System is arming
Problem was
identied during the
incomplete arming
(detection in and
instant area)
The LEDs will stay
on for 5 seconds
The indicators goes off, the system is disarmed.
There was no alarm
An alarm triggered
on
The top indicator
ashes green for
2s, and that of the
bottom ashes
xed green light
and the reader
beeps 4 times
The two
indicators
remain on with
xed green light
for 5 seconds
When reading the badge, the reader emits a beep, then two
beeps indicating the badge has been accepted. The LED
indicators of the reader are going to indicate a message:
When reading the badge, the reader emits a beep, then two
beeps indicating the badge has been accepted. The LED
indicators of the reader are going to indicate a message:
Functioning of indicators
The complete functioning of the indicators is only possible with the XL / XT / XV / VISIO v5.2 / V6000 V31.02 or superior control
panels.
During disarming
Verify with a keypad in
order to know more about
what happened
INSTALLATION DATA SHEETOutdoor Badge Reader BR651