Operator's Manual

Page 14
Version 1.4
Copyright © 2019 RSAE Labs
08-Apr -2019
3.3. Connecting Battery Charger
Use the procedure below to connect the battery pack to the charger and charge the batteries for the
next mission.
Step
Action
Picture
1
If not already separated, remove the battery
pack from the main housing as described in
Section
3.2 above.
2
Connect the battery to the charger as shown.
The charger interface adapter is keyed to
prevent reversal of the battery terminals.
DO NOT USE FORCE to connect the charger
interface adapter to the battery pack.
3
If charger was not previously connected,
connect charger to wall outlet and verify the
charger light turns yellow. It will not change
color until a battery is connected.