Operator's Manual

Page 13
Version 1.4
Copyright © 2019 RSAE Labs
08-Apr -2019
Step
Action
Picture
1
Remove the screws holding the battery to the
device using a 5/32” x 125 hex head driver.
Remove both left and right screws until the
battery pack separates.
Note that these screws are designed to be
captive. Keep screws with the battery pack.
2
Separate the battery pack from the main
housing.
3
Inspect battery terminals and verify there is
no damage. Check both the battery pack and
main housing terminals shown.
Discard the battery as damaged if the
terminals are not straight or intact as shown
in the figure below.
4
Wipe the battery terminals with a clean cloth.