Troubleshooting guide
4: Primary Server Migration 71
RSA Authentication Manager 6.1 to 8.1 Migration Guide
5. Review the Scan Results screen to verify that the data found in the dump file is the
data you want to migrate.
6. Select Custom Mode,
7. (Optional) If you are attempting to migrate a version 6.1 instance that you have
already migrated, you will see the Migration Retry Cleanup section on the Scan
Results page. When the checkbox is enabled, the version 8 instance is prepared for
a migration retry. Ensure that you have deleted the version 6.1 migration data in
the version 8.1 instance before proceeding.
Disable this checkbox if you are not performing a migration retry, or for the
following scenarios:
• If your migration process consists of multiple version 6.1 dump file. For
instance, one dump file contains only users, and another dump file contains
only tokens.
• You have not deleted the previously migrated data before attempting a
re-migration.
8. Click Next.
9. To run a test migration, select Create output report without performing actual
migration.
You can review the migration reports to see what would happen if you ran the
actual migration with your chosen settings.
10. Do one of the following to indicate how you want the migration process to handle
data conflicts:
• To continue with the migration and describe conflicts in the migration report,
select Best Effort.
• To stop the migration and describe conflicts in the migration report, select No
Conflict.
11. Review the items in the Select objects to migrate section of your RSA
Authentication Manager 6.1 dump file. Verify that the selected items are the
objects that you want to migrate. Clear any objects that you do not want to
migrate.
If you are migrating RADIUS 6.1 data and want to migrate both RADIUS settings
(such as policy settings) and RADIUS data (profile names, user profile
assignments, and RADIUS agent hosts), you must select both Migrate System
Settings and Migrate RADIUS in the Select objects to migrate section.
Migrate Agents is displayed in the list of objects to migrate only when
auto-registered agents are found in the dump file. If you want to maintain the
existing agent IP addresses of the auto-registered agents, make sure that the
Protect all IP addresses checkbox below Migrate Agents is selected.