Specifications

PAGE 14

AINING SOLUTION TANK

TO DRAIN LEFT OVER CLEANING SOLUTION FROM THE SOLUTION

TANK, PERFORM THE FOLLOWING STEPS.

(SEE FIGURE 18.)

1. PULL THE CLEAR SIGHT TUBE/DRAIN HOSE OFF BARBED ELBOW.

2. RINSE OUT TANK AND SOLUTION FLOW SYSTEM WITH CLEAN

WATER.

FIGURE 18.

ADJUST SOLUTION FLOW

1. TURN SOLUTION VALVE ADJUSTMENT LEVER (A)

CLOCK-WISE TO INCREASE SOLUTION FLOW,

COUNTER-CLOCKWISE TO DECREASE SOLUTION FLOW.

(SEE FIGURE 15.)

JUST SHROUD CURTAIN

1. RELEASE LATCH ON SIDE OF SCRUBDECK SHROUD

TO LOOSEN CURTAIN BANDS. (SEE FIGURE 16.)

2. RAISE OR LOWER CURTAINTO DESIRED HEIGHT.

3. RECONNECT LATCH AND SNAP SHUT TO TIGHTEN BANDS.

FIGURE 16.

AINING RECOVERY TANK

ALWAYS EMPTY RECOVERY TANK WHEN REFILLING THE SOLUTION

TANK. YOU CAN REFILL THE SOLUTION TANK WHILE THE RECOVERY

TANK IS DRAINING. TO DRAIN THE RECOVERY TANK, PERFORM THE

FOLLWING STEPS.

1. REMOVE DRAIN HOSE FROM THE J-HOOK AND REMOVE THE

CAP. (SEE FIGURE 19.)

FIGURE 19.

ADJUST "PAD ASSIST" DRIVE

1. TURN ADJUSTMENT KNOB CLOCK-WISE TO INCREASE DRIVE

SPEED. (SEE FIGURE 17.)

2. TURN KNOB COUNTER-CLOCKWISE TO DECREASE DRIVE SPEED.

FIGURE 15.

FIGURE 17.