Specifications

ONE PASS SCRUBBING
(SEE FIGURE'S 13 & 14.)
1. TURN ON MACHINE POWER SWITCH "A" ,
MAKE SURE THE "PAD ASSIST" ADJUSTMENT KNOB
IS A LOW SETTING.
2. LOWER SQUEEGEE BY ROTATING THE LIFT LEVER
"B" COUNTER-CLOCKWISE.
3. LOWER SCRUB HEAD TO THE FLOOR, USE THE
TOP HALF (+) OF THE BRUSH SWITCH "C".
4. TURN ON THE SOLUTION SWITCH "D".
5. TURN ON THE VACUUM MOTOR SWITCH "E".
6. BEGIN SCRUBBING BY DEPRESSING THE GREEN
CONTROL BUTTON "F". ADJUST THE "PAD ASSIST"
ADJUSTMENT KNOB TO THE DESIRED SETTING.
7. ONCE THE MACHINE BEGINS TO MOVE,
CHECK THE DOWN PRESSURE GAUGE "G".
START SCRUBBING AT THE MIDDLE.
DO NOT SCRUB IN THE RED, OR THE CIRCUIT
BREAKER WILL BLOW.
8. TO STOP THE MACHINE, LET GO OF THE GREEN
CONTROL BUTTON "F".
FIGURE 13.
B
FIGURE 14.
A
C
D
F
G
E
PAGE 13
SC
RUB ONLY
(SEE FIGURE 14.)
1. TURN ON MACHINE POWER SWITCH "A",
MAKE SURE THE "PAD ASSIST" ADJUSTMENT KNOB
IS A LOW SETTING.
2. LOWER SCRUB HEAD TO THE FLOOR, USE THE
TOP HALF (+) OF THE BRUSH SWITCH "C".
4. TURN ON THE SOLUTION SWITCH "D".
5. BEGIN SCRUBBING BY DEPRESSING THE GREEN
CONTROL BUTTON "F". ADJUST THE "PAD ASSIST"
ADJUSTMENT KNOB TO THE DESIRED SETTING.
6. ONCE THE MACHINE BEGINS TO MOVE,
CHECK THE DOWN PRESSURE GAUGE "G".
START SCRUBBING AT THE MIDDLE.
DO NOT SCRUB IN THE RED, OR THE CIRCUIT
BREAKER WILL BLOW.
7. TO STOP THE MACHINE, LET GO OF THE GREEN
CONTROL BUTTON "F".
VAC
UUM ONLY
(SEE FIGURE'S 13 & 14.)
1. TURN ON MACHINE POWER SWITCH "A".
2. LOWER SQUEEGEE BY ROTATING THE LIFT LEVER "B"
COUNTER-CLOCKWISE.
3. TURN ON VACUUM SWITCH "E".
4. PUSH MACHINE FORWARD OVER SOLUTION.