Specifications

PAGE 8
C
ONTROLS AND FUNCTIONS
SEE FIGURES (1-4) ON PAGE 7
SEE FIGURE 1
1. MAIN POWER SWITCH: TURNS THE MACHINE ON AND OFF.
2. VACUUM SWITCH: TURNS VACUUM MOTOR ON.
3. SOLUTION SWITCH: OPENS AND CLOSES SOLUTION VALVE.
4. SCRUB DECK SWITCH: RAISES AND LOWERS SCRUB DECK (PROVIDES AJDUSTMENT +/- FOR PRESSURE).
5. BATTERY GAUGE: INDICATES AMOUNT OF BATTERY CHARGE .
6. POWER LIGHT (GREEN): INDICATES POWER "ON".
7. DOWN PRESSURE GAUGE: INDICATES AMOUNT OF PAD/BRUSH PRESSURE.
SEE FIGURE 2
8. EMERGENCY STOP (OPTIONAL): SHUTS OFF POWER TO THE MACHINE .
9. KEY SWITCH (OPTIONAL): TURNS POWER ON TOTHE MACHINE.
10. CIRCUIT BREAKER: 2 AMP RESETABLE CIRCUIT BREAKER (ACTUATOR).
11. CIRCUIT BREAKER: 25 AMP RESETABLE CIRCUIT BREAKER (VACUUM MOTOR).
12. CIRCUIT BREAKER: 30 AMP RESETABLE CIRCUIT BREAKER (SCRUB MOTOR).
13. SPRAY JET (OPTIONAL): TURNS ON THE SPRAY JET PUMP (BLUE).
14. HOUR METER: INDICATES HOW MANY HOURS THE MACHINE HAS BEEN RUN.
15. SERIAL NUMBER PLATE: MACHINE IDENTIFICATION.
SEE FIGURE 3
16. RECOVERY LID: USED FOR FLUSHING OUT RECOVERY TANK AREAWITH FRESH WATER.
17. DRIVE BUTTON: DEPRESS TO DRIVE FORWARD, RELEASE TO STOP. (STARTS & STOPS THE SCRUB MOTOR)
18. "DRAIN SAVER" STRAINER: HELPS PREVENT CLOGGING OF DRAIN PORTS.
19. VAC SCREEN: PROTECTS VAC MOTOR FROM DEBRIS.
20. CASTER: TWIN CASTERS FOR STABILITY.
21. MAIN TIRE: NON-MARKING TIRES.
22. SOLUTION VALVE: CONTROLS SOLUTION FLOW RATE, WHEN SOLUTION SWITCH IS ON.
23. SPLASH CURTAIN: HELPS CONTAINWATER INSIDE SCRUB AREA.
24. WALL ROLLERS: HELPS PROTECT MACHINE WHEN SCRUBBING NEAR WALLS.
25. "PAD ASSIST" DRIVE ADJUSTMENT KNOB: ADJUSTS AMOUNT OF OFFSET BEING APPLIED TOBRUSH.
26. TANK-IN-TANK: SOLUTION/RECOVERY TANK(18 GALLON CAPACITY EACH).
27. SOLUTION FILL LID: FILL PORT FOR FILLING SOLUTION TANK.
SEE FIGURE 4
28. CLEAR COVER: FOR VIEWING INSIDE RECOVERY TANK AREA.
29. CONTROL PANEL: MACHINE CONTROLS.
30. RECOVERY DRAIN HOSE: ALLOWS FOR CONTROLLED DRAINING OF RECOVERY TANK.
31. RECHARGE PLUG: RED 50 USED TO RECEIVE CHARGER INPUT. NOTE: ONLY USE CHARGER PROVIDED.
32. BATTERIES: YOUR MACHINE IS EQUIPPED WITH TWO (12 VOLT DEEP CYCLE 140 AMP HOUR BATTERIES).
33. SQUEEGEE BLADE: RECOVERS DIRTY WATER FROM FLOOR TOBE RECOVERED BY THE VACUUM HOSE.
34. VACUUM HOSE: VACUUMIZES SQUEEGEE. NOTE: KEEP FREE AND CLEAR OF BLOCKAGE.
35. SQUEEGEE PITCH ADJUSTMENT: ADJUSTS PITCH OF SQUEEGEE. DEFLECTION SHOULD BE EVEN ACROSS ENTIRE BLADE.
36. SQUEEGEE LIFT POST: LIFT TO RAISE SQUEEGEE AND PUSH DOWN TO LOWER SQUEEGEE.
37. SOLUTION FILTER: HELPS CLEAN WATER IN PREPERATION FOR SCRUBBING.
38. SOLUTION LEVEL INDICATOR & DRAIN TUBE: SHOWS PRECISE LEVEL OF CLEANING SOLUTION INTANK & DRAIN PORT.