Service manual

Electrical Service Manual V4.0
10
10-8
TRIO PROGRAMMING
22. Close out all remaining windows.
23. Open INDUSTRIAL/PC Programmer
24. When you open INDUSTRIAL/PC Programmer you may get an error window that says
“Can’t open Serial port” click the “OK” button.
25. When the “Industrial Programmer” window opens up click on the “Configure” tab on the
top of the window.
26. You do not want the check mark next to the “Standard COM Enumeration”. If there is a
check mark there click on the check mark and it will go away.
27. Click on the “Tools” tab on the top of the window.