Service manual

Electrical Service Manual V4.0
6
6-10
CENTRAL COMMAND II
SCREEN 3
To access this from screen 1, press the green page button
twice.
9: BATTERY METER - This meter shows the charge level of
the batteries in the machine. This gauge is designed to read
properly while the machine is in use and therefore will vary
during usage of the machine.
10: SCRUB HOURS - The hour total listed here indicates the
total number of hours the brush deck has been operated on
the machine.
11: TRACTION HOURS - The hour total listed here indicates
the total number of hours the traction drive has been oper-
ated on the machine.
12: KEY SWITCH HOUR METER - This hour meter rep-
resents the total number of hours the machine has been
powered on. This does not mean however that the machine
has been used this long just that it has had the power on for
the time indicated.
9. BATTERY GAUGE
10. SCRUB HOURS
11. TRACTION HOURS
12. KEY SWITCH HOURS
SCREEN 4
This screen will appear automatically in the event of a fault
being present in the machine. Machine operation will be
suspended until the cause of the code is remedied.
FAULT CODE
SCREEN 2
To access screen 2, push the green page button on the con-
trol panel once.
7: KEY SWITCH HOUR METER
This hour meter represents the total number of hours the ma-
chine has been powered on. This does not mean, however,
that the machine has been used this long, just that it has had
the power on for the time indicated.
8: BATTERY METER
This meter shows the charge level of the batteries in the
machine. This gauge is designed to read properly while the
machine is in use, and therefore will vary both up and down
during usage of the machine.
7. KEY SWITCH HOUR METER
8. BATTERY METER