Service manual

Electrical Service Manual V4.0
3
3-1
CURTIS 1213 CONTROLLER










CURTIS 1213
The Curtis 1213 controller was used on our model 48 sweepers
until 1997. The controller is an adjustable controller that has true
regenerative braking that also provides complete downhill decel-
eration and speed control. This controller required no forward and
reverse contactor due to its full bridge design.
FEATURES
- Full bridge power MOSFET design.
- Silent operation
- Current limiting in both drive and brake modes
- Potentiometer adjustable acceleration, deceleration and reverse speeds
- Power failure default braking
- Anti rollback/roll forward circuitry
- Terminal overload protection
SPECIFICATIONS
Operation Voltage: 24 Volts
Controller capacity: 200 amps
Outputs
Traction Drive
Main Power Relay
Brake
The 1213 controller was adjustable but not programmable
The 1213 controller required suppression diodes be wired in parallel to the coil side of the
solenoid.