Service manual

2023 Service Manual V1.0
5
5-2
RECOVERY SYSTEM
To clean:
Remove the white retaining clamp from the screen.
Pull the vac screen / float ball assembly off the vac
box.
Rinse with hot water. Scrub with a brush if neces-
sary
Dry thoroughly.
Replace vac screen / float ball assembly onto vac
box.
Replace and tighten clamp.
BAFFLE ASSEMBLY
The baffle assembly is also located inside the recovery tank and accessed by opening the
recovery tank lid. The baffle adds rigidity to the tank walls and lessens the sloshing of the
water inside the recovery tank.
VACUUM FLOAT
The vacuum float assembly is located inside the
recovery tank and is accessed by opening the re-
covery tank lid. The float stops the flow of air in the
event that the recovery tank is filled to capacity.
DRAIN HOSE
To drain the recovery system the machine is
equipped with a poly hose with an integrated flow
control feature. By squeezing the hose the flow
of the waste water from the recovery tank can be
metered as it is being emptied. The hose cap is
attached to the hose with a tether to help prevent
loosing it.
RETAINING
CLAMP
VAC
SCREEN
BAFFLE
ASSEMBLY