Service manual

2023 Service Manual V1.0
2
2-2
MACHINE INTRODUCTION
MAIN COMPONENTS
Handle Bars (1) - The handle bars are located at the back of the machine and have a green button
on the right side handle. When the green button is depressed it turns on the brush motor and solu-
tion flow if the control panel switches are turned on.
Recovery Tank Lid (2) - The recovery tank lid is equipped with a clear dome to allow you to see
the condition of the recovery tank while in use. You are able to observe both the recovery water
level as well as observe if their is foam accumulating in the tank. The lid opens to expose the re-
covery tank in it’s entirety allowing it to be completely cleaned out. When the cover is open you are
able to access the float assembly (17) and the Drain Saver (16).
Control Panel (3) - The control panel is located at the top rear of the machine and houses the
switches and circuit breakers used to operate the machine.
Circuit Breakers (4) - The circuit breakers are used to protect the machine from both short circuits
as well as circuit overloads.
Solution Drain Hose / Sight Gauge (5) - This hose serves as the drain for the solution tank as well
as the sight gauge to show the level inside the tank.
Squeegee Tool (6) - The complete squeegee assembly that picks up the water from the floor.
Front Wheels (7) - The front wheels are a non slip rubber compound to keep the scrubber under
control.
Rear Casters (8) - The rear casters are a chemical resistant poly material that rolls well and resists
wear.
Solution Filter (9) - The solution filter is located underneath the bottom of the scrubber directly
above the squeegee linkage and filters the solution before is flows through the machine.
Squeegee Lift Lever (10) - The squeegee lift lever is located at the rear of the machine near the
floor and has a high visibility yellow cover on it. It was designed to be easily operated with a foot.
Battery Charger Port (11) - The plug where you plug in the battery charger
Recovery Tank (12) - The recovery tank holds the dirty water that is removed from the floor by
the squeegee. The capacity of it is 33 gallons. The tank additionally holds the float assembly, that
closes the path to the vacuum motor when the recovery tank is full, and the Drain Saver that catch-
es large debris that are collected through the squeegee tool.
Recovery Drain Hose (13) - This hose is used to empty the dirty water from the recovery tank.
The hose opening can be restricted with your hand to regulate the rate of discharge.
Body Lock Down Screw (14) - The body lock down screws are recessed into the sides of the
scrubber. You use the supplied Body Allen Wrench to remove these and open the scrubber to gain
access to it’s inside components.
Body Allen Wrench (15) - This wrench is supplied to remove the body lock down bolts.
Drain Saver Screen (16) - The drain saver screen is designed to catch large debris that the squee-
gee picks up so your recovery tank stays cleaner and the drain hose does not clog.
Vacuum Float & Screen (17) - The vacuum float and screen are designed to stop the flow of air to
the vacuum in the event that the recovery tank fills completely so that the vacuum motor does pass
water and to keep foreign objects from entering the vacuum motor.
Solution Valve (18) - The solution valve starts and stops the flow of water to the brush assembly.
Solution Fill Door (19) - The solution fill door is where you ad clean scrubbing water and soap to
the solution tank. The solution tank holds the water and/or chemicals used to clean the floor. Use
only approved detergents. Capacity is 35 gallons.
Brush Drive Adjuster (20) - The brush drive adjuster increases or decreases the amount of drive
assistance the machine outputs.