Installation Instructions

Eclipse
™
Energy Guard
PO Box 1110 | Alexandria, LA 71309
[phone] | royomartin.com
6.0 Typical Triangular Vent Installation
Product Information & Installation Manual 06
Printed October 2009 I Made in the USA I © 2009 RoyOMartin
6.1 Fasten Eclipse™ Radiant Barrier Panels to wood
frame and apply
approved Energy Guard tape as
detailed in section 2.0.
(See Figure 6.1)
6”
6”
6.2 Measure and cut IBC-approved adhesive ashing
length at least 12 inches longer than
horizontal
length of
vent jamb.
(See Figure 6.2A)
Flashing width should be sufficient to cover
vent jamb plus a minimum of 2 inches on exterior
Eclipse™ Radiant Barrier Panel.
(See Figure 6.2B)
Notch, fold and apply flashing to cover
vent jamb, ensuring a 6 inch long strip of
flashing to both triangular sides.
(See Figure 6.2C)
6.3 Install vent according to manufacturer’s
instructions, adhering to all local building codes.
(See Figure 6.3A)
Measure and cut
IBC-approved adhesive ashing
length at least 2 inches longer than triangular
length of
vent. Apply flashing overlapping vent
frame at least 1 inch and overlapping flashing at
top of triangular frame.
(See Figure 6.3B)
Figure 6.2A
Figure 6.1
Figure 6.2B
Figure 6.3A Figure 6.3B
Figure 6.2C
2”
2”
2”
WIDTH
OF VENT
JAMB
6”
6”