Technical Specifications

This product is designed to meet international building codes; however, local building codes may supersede. These instructions are not intended
to cover every installation requirement, application, detail or variation, nor do they provide for every possible installation contingency. If any
questions or problems arise concerning the installation of this product or its suitability for the purchaser’s particular use, inquiries should
be made to RoyOMartin. The information about products and application instructions printed herein is current at the time of publication;
however, in accordance with RoyOMartin’s policy of constant product improvement, the right is reserved to vary these application instructions
and product specications without notice. When placing your order, ask for the most recent product information.
Engineered for Performance and Value
Finally, a quality panel engineered specically for the concrete forming industry
that produces a great nish with fewer headaches. RoyOMartin’s GreenCore
Plyform™ is a cost-effective forming solution for a more protable bottom line.
Classications
Exterior- Plywood suitable for repeated wetting and redrying or long-term
exposure to weather and other conditions of severity.
Strength-True to Form
As a Group l species, GreenCore Plyform™ is classed among the strongest and
stiffest forming material in the industry. The BBOES structurally rated plyform
is composed of a B-grade on both faces with C-grade inner plies cross-banded
for strength. Both surfaces are fully repaired, sanded, edge-sealed and pre-oiled
with a superior chemically reactive release agent. As an exterior rated product,
GreenCore Plyform”’ is bonded with an exterior resin and is designed for
applications subject to permanent exposure to wet conditions.
Struct 1 Certied Plyform
GreenCore Plyform™ panels are certied by APA-The Engineered Wood
Association-and are in compliance with APA Performance Rated Panels™, PS 1-07.
For your assurance, an APA stamp conrming compliance appears on each panel.
Save Material, Time and Labor
GreenCore Plyform™ makes it easy to produce quality results on a wide variety of
concrete-forming applications, including walls, decks and pillars. Working with
GreenCore Plyform™ is very user-friendly. Nails can be placed near the edges of
panels without splitting the wood. Panels can be attached to steel or aluminum
with mechanical fasteners using self-drilling, self-tapping screws or hardened
helically-treated nails. No special tools are required. GreenCore Plyform™ can be
cut, drilled, routed, jointed, glued, fastened and nished with ordinary tools, just as
you would with ordinary plywood.
Preparing Panels for Use
Panels are factory-treated with a chemically reactive release agent; however,
RoyOMartin cannot control the length of time between manufacture and actual
use. The release agent’s effectiveness can dissipate over time. It is recommended
that a light application of release agent be given prior to the rst use and each
subsequent use with a chemically reactive release agent that will not bond
with, stain or adversely affect concrete surfaces. Follow the manufacturer’s
recommendations for application.
Cleaning
Caution should be observed when removing panels so as not to damage panels or
separate veneers from the factory glue bond. After stripping, remove loose residual
concrete and re-oil with a recommended chemically reactive release agent.
Certication
GreenCore Plyform™ panels are certied by APA-The Engineered Wood
Association and are available Forest Stewardship Council
®
(FSC
®
) certied.
Class C re rating. Meets CA Resource Board (CARB) regulations.
Length
*
Lengths are nominal. All widths are 48″ (nominal)
Thickness
19/32 & 23/32
Performance categories
96
Length
Lengths are nominal. All widths are 48″ (nominal)
Thicknesses
19/32 & 23/32
Performance categories