Manual

Features
• Very high overload characteristics – maximum SPL greater than 135dB
• Active electronics offer greatly enhanced output and a constant, optimized impedance to the
ribbon element
• Extremely low residual noise
• Ribbon element is unaffected by heat or humidity
• Absence of high frequency phase distortion
• Excellent phase linearity – even off axis
• Equal sensitivity from front or back of element
• Consistent frequency response regardless of distance
• Compact size
Electrical Specifications
Acoustic Operating Principle: Electro-dynamic pressure gradient
Polar Pattern: Figure-8
Generating Element: 2.5 micron aluminum ribbon
Frequency Range: 30 – 15,000 Hz ± 3dB
Sensitivity: -36 dB (Ref 1 v/pa ± 1dB)
Self Noise: <18dB
Output Impedance: 200 Ohms, balanced
Rated Load Impedance: 1K-Ohm minimum
Maximum SPL: 135dB @ 30 Hz
Output Connector: Male XLR 3 pin (pin 2 hot)
Power Requirements: 48-Volt phantom only
Supply Current: 4 mA
All Royer monaural microphones are also available in matched pairs.
18