User manual

BM-6280 User manual
~ 26 ~
Hardware Support – Line 0700 - EASYCARE
have successfully activated the COM1 port.
4. Click on Save.
 The GPS receiver does not start automatically.
Solution:
GPS cannot be initialized even after the configuration of the COM1
port,
1. Close the navigation program.
Check the GPS reception settings under Start – Settings – System –
GPS. It is recommended to use the automatic start when
accessing COM1. Restart the navigation program.
The display jitters / slows down, responds sluggish or the program
aborts.
This may be due to reduced memory availability. Normally, The
navigation software requires approximately 10-15 MB of free main
memory (for swapping-out files, etc.). If this is no longer available,
the stated problems may arise. The Pocket PC may also go into
energy-saving mode, which can lead to the memory card no longer
be recognized correctly.
Solution:
 Close down all programs.
 Delete unnecessary files (MP3, PDF etc.) or save them
externally.
 Start the navigation program again.
 Carry out a soft-reset (see page 16).
ADDITIONAL SUPPORT
If the suggestions in the above section have not solved your
problem, please contact your local reseller or visit bluemedia web
site. However, before you contact your service people, please have
the following information available:
- How is your computer configured?
- What additional peripherals do you use?
- What messages, if any, appear on your screen?
- What software were you using when the error occurred?
- What steps have you already undertaken to solve the problem?
- Have you upgraded or removed drivers or hardware?
- Can you manually repeat the problem?