User manual

6
7
I N D USTRI A L
DIV ISION
A NIM A L
D I V I SION
LIVESTOCK
TECHNOLOGY
I N D USTRI A L
DIV ISION
A NIM A L
D I V I SION
LIVESTOCK
TECHNOLOGY
8. By pressing the selection button , you will have access to the
setting menu.
Please refer to section 3, Menu Functions, for a complete description
of the meaning of the various preset functions of the scanner,
7. To scan the transponder. Press the scanning button (see page 4)
depicted to the side. Two red LED flash alternatively.
- Category (Animal), beside Animal/Not animal, appears a number
(if Selected “Switch ON REC” function) indicating the positioning into
the memory of ID codes
- Type of transponders (HDX/FDX-B found)
- Country (C)
- Species (S)
- Re-tagging counter (R)
- Code
9. Battery charge level indicator.
10. Keybord
11. Auto shutdown is set to 60 seconds.
Since the switching on or after performing a reading after 20 sec. from
read, the code disappears and returns to the screen with the logo.
After 40 seconds, the reader turns off automatically.
12. In the “Energy Save”, the auto power off is set to 20 sec.
When the transponder is read the buzzer emits a warning sound. The
transponder is associated to the lot which has been selected as shown
later
On the screen it appears:
“Tag not found”. If you read a tag already detected before,a Double read
which are:
- memory report
- - erase memory
- energy save/full power
- choice of LOT
- LOTS report
- erase LOTS
If you read a transponder not usable for animals, it appears on the screen
in red : “This is not an animal tag"
If no Transponder was read, in “Full Power” mode after 14 sec. it appears
message will be displayed in red; if the double tag has already been stored
different LOT there
will be the possibility to save it by clicking the selection
button
in the LOT you're using, it won't be saved while if it has been stored in a