User manual

2
3
I N D USTRI A L
DIV ISION
A NIM A L
D I V I SION
LIVESTOCK
TECHNOLOGY
I N D USTRI A L
DIV ISION
A NIM A L
D I V I SION
LIVESTOCK
TECHNOLOGY
Table of content
1. Introduction ------------------------------------------------------ 4
2. Quick use guide ------------------------------------------------- 5
3. Menu functions --------------------------------------------------- 8
CE conformity declaration
The manufacturer declares that the I-Read scanner complies with the requirements prescribed by the
following European regulations: 73/23/EEC, 93/68/EEC and 89/336/EEC.
In particular, the following standards were used to verify the compliance described in the preceding
point:
-ETSI EN 300 330-2 V1.3.1 (04/2006)
-ETSI EN 300 330-1 V1.5.1 (04/2006)
-EN 301 489-1 V1.8.1 (2008)
-EN 301 489-3 V1.4.1 (2002)
-EN60950-1(2006 +A11: 2009)
FCC conformity declaration
This device complies with what is indicated in Part 15 of the FCC regulation “Low Power Transmitter
Below 1705 kHz”. Usage is subject to the following two conditions:
1) This device must not cause harmful interference
2) This device must accept any interference received, including that which could produce undesired
usage
To request a copy of the certicate, please contact: [e-mail]
© Copyright 2010 by Royal Tag SA
®
All rights reserved. No part of fhis publication may be reproduced, stored in a retrieval system or transmitted in any form or by
any means, electronic,
mechanical, photocopying, recording or otherwise without the prior written permission of the Royal Tag SA®.
Royal Tag SA® reserves the right to make changes to part of this documentation without obligation to notify any person or entity
of such changes.
IC conformity declaration
This ISM device complies with IC (industry Canada) specication ICES-001, RSS-210 Issue 8,
RSS-GEN Issue 3, RSS-102 Issue 4
RoHS conformity declaration
We hereby declare that this product is manufactured as per the requirements of Directive 2002/95 CE
(RoHS)
Industry
Canada
IC: 9508A-2011001
RoHS
WARNING
Do not make any change or modication to the device unless expressly specied in the manual.
If it is necessary to make these changes or modications, it could be necessary to interrupt the use of the device.
3.3 Memory report 9
3.6 Energy save/Full power 11
3.5 Erase memory 10
4. Download the mass storage mode data --------------------- 12
5. Insertion of the aliases ----------------------------------------- 13
5.1 Alias syntax 14
3.2 LOTS report 8
3.1 Choice of LOTS 8
6. Insertion of the custom LOTS----------------------------------- 17
3.4 Erase LOTS 9
March 2012 (GP/LUG)
6.3
6.2 Custom LOTS uploading 18
6.1 LOTS syntax 17
6.3 Troubleshooting 19
6.4 LOTS data downloading 19