User manual

RSC-1650H/C/HR
Speed# Speed(Ft/min,M/min)
1 4(1.2)
2 6(1.7)
3 7(2.2)
4 9(2.6)
5 10(3.1)
6 12(3.6)
7 14(4.2)
8 15(4.5)
9 16(5.0)
RSC Series
87
7. SPEED AND TEMPERATURE SETTINGS
8. ROLLER NIP SETTING
RSC-1650H RSC-1650HR
Temp.# Temperature( F, C ) Temperature( F, C)
1 No Heating No Heating
2 No Heating 86(30)
3 91(33) 113(45)
4 97(36) 140(60)
5 104(40) 230(110)
6 111(44) 239(115)
7 115(46) 248(120)
8 117(47) 257(125)
9 124(51) 266(130)
It is important to adjust the roller nip settings to the appropriate thickness of the board
being used. Use the guide below to adjust to the correct position.
NO. Inches
Metric
(mm)
1 Lamination Lamination
2 1/ 25" 1
3 3/16"~1/4" 5-7
4 3/ 8"~1/2" 10-13
5 3/5" 15
NOTE: If you don't want to laminate,
please place the pressure lever to the
"Open position(NO.5)."
9. USING FOOT PEDAL AND REMOTE CONTROL
10. USING CROSS CUTTER
USING FOOT PEDAL
Place the foot pedal on the floor in front of the machine.
Once all correct settings are displayed, you may use the
foot pedal to operate the laminator for “Hands Free
Operation.” To activate the machine, press the foot pedal
once and then release. Repeat to stop the rollers.
The cross cutter is located on the rear exit table of the machine.
1. After lamination, move the cutter approximately to the
center of the completed application at the desired point
of detachment (Figure 1).
2. Grasp film with one hand, press the cutter
downward into the application and slide it first to one
end of the application, then to the other end to
complete the cut (Figure 2 & 3).
USING REMOTE CONTROL
Located on the left hand side of the rear of the laminator, to
use press:
1.
RUN: To activate the rollers.
2.
STOP: To stop the rollers from turning.
3.
REV: To reverse the rollers. Press and hold the button
(useful for jams or misfed media).
12 3
Figure 1
Figure 2
Figure 3