Installation Manual HY-Y202,Y204,Y350,Y360 1
Introduction We congratulate you on your new path to better health! Thousands of users enjoy the benefits of an infrared sauna every day. Now you can enjoy the great benefits of far-infrared heat within the privacy of your own home. Please read this manual carefully and thoroughly before using an Infrared Sauna for the first time. We recommend for you to keep this manual for future reference.
Packing List For any missing parts please contact your local distributor. 1. Front panel 2. Back panel 3. Side panel (L) 4. Side panel (R) 5. Top panel 6. Bench panel 7.
Installation Requirements 1. Install the sauna on a completely level floor. 2. Do not spray the exterior with water. If the floor is damp, install a floor separator to keep the sauna high & dry. 3. Do not store flammable objects or chemical substances near the sauna. 4. The sauna must be placed indoors and in a dry area. Moisture will cause damage to the interior and exterior of the sauna.
Assembly Instructions Assembly of the sauna requires at least 2 adults to complete. Please read the instructions thoroughly before and during assembly to ensure proper installation of the sauna. <1> LOCATION OF SAUNA When you find a good location for your sauna, please notice the following. 1. The main power cord on the sauna must be easily accessible. 2. The location must be dry and leveled. <2> PLACING BOTTOM PANEL Front Place the bottom panel on the floor.
<4>CONNECTING SIDE PANELS WITH BACK PANEL Align the side panels with back panels’ corresponding outside-buckles. Make sure the outside-buckles on both side panels and fixed in place. Outside buckles <5>INSTALLING THE BENCH HEATER Slide down the bench heater panel by lining up its sides with the vertical guides on side panel. 1. The heater grill is facing outward (toward the front of the sauna). 2. Push the bench heater panel all the way down until it is touching the bottom panel and securely in place.
<7> INSTALLING THE BENCH 1. Install the bench by sliding it over the horizontal bench guides on the side panels. Keep the two little blocks on the bottom to the front side. 2. Push the bench all the way in until it can touch the back panel and is securely in place. <8> CONNECTING THE FRONT PANEL TO SIDE PANEL Outside buckles <9> PLACING TOP PANEL Lower the roof panel onto the assembled panels. 1. Gently place the top panel onto the rest of the assembled panels.
<10> THE MAIN POWER CONNECTION ON THE TOP PANEL 1. Connect all the wires for heaters. 8. Connect the control panel wires. 3. Check if all connections to the control box are secure.
11> INSTALLING DOOR HANDLE <12> ENJOY YOUR SAUNA! Plug in the main power cord into the wall outlet and power up your sauna.
Digital Control Panel Operating Instructions 1. Power on Plug the main power cord into the wall outlet. Press the “On/Off” button one time, the control panel is now operable, but the heaters are not on. You can now use the radio and lights. 2. Warming Press “On/Off” button again, then the “Warming” light is on, which indicates the heaters are working. To turn off the sauna, press the ON/OFF button. 3. Lighting The reading light can be turned on or off by pressing button at any time. 4.
5. Sauna Time Adjustment Session time can be set between 0 and 90 minutes. a) Press TIME UP/DOWN ARROWS to adjust time, time value will increase or decrease by 1 minute at a time. b) By holding down the UP/DOWN ARROWS you can speed up the rate of change. c) Time light will be lit to indicate changes being made to time setting. d) If you don’t input anything during 5 seconds, the TIME DISPLAY will stop flashing, the value will be stored in memory as preset value.
Things To Know 1. Set up the desired session temperature and time using the control panel. ( suggested 100℉-130℉) 2. Allow approximately 10~15 minutes for the sauna to warm up before beginning a session. 3. Recommend sauna session use is around 30-45 minutes. 4. The heaters automatically maintain the desired temperature inside the sauna 5. The ceiling vent can be opened at any time to for air circulation. 6. Always drink plenty of water before, during, and after a session.
Recommendation for Use 1. To regulate the temperature inside the sauna during your session, use the roof vent or the door (by setting it at an angle). 2. If you need more cooling, simply leave the door open until the air around you feel comfortable. 3. Drink plenty of fluids prior to, during, and after your sauna session. 4. If you take a hot /warm shower or bath before your sauna session, you may perspire more. Try it with and without bathing or showering first to determine which way you prefer. 5.
Safety Read all health and safety instructions. If in doubt as to the advisability of using your infrared sauna, consult with your physician prior to use. If you feel light-headed or heat exhaustion during session, exit the sauna immediately. 1. Read and follow all instructions carefully. 2. When installing and using this electrical equipment, basic safety precautions should always be followed. 3. To reduce the risk of injury, do not allow children to use the sauna unless they are closely supervised at all.
9. Persons using medications should consult a physician before using the sauna since some medications may induce drowsiness while others may affect heart rate, blood pressure, and circulation. 10.Never sleep inside the sauna while the unit is in full operation. 11.DO NOT use any type of cleaning agents on the interior of the sauna. 12.DO NOT stack or store any object on top of or inside the sauna. 13.
Important Safeguards For Your Sauna 1. READ INSTRUCTIONS -- All the safety and operating instructions should be read before the sauna is installed and operated. 2. RETAIN INSTRUCTIONS -- The safety and operating instructions should be retained for future reference. 3. FOLLOW INSTRUCTIONS -- All operating and usage instructions should be followed at all times. 4. CLEANING -- Unplug the sauna from the wall outlet before cleaning DO NOT use liquid cleaners or aerosol cleansers inside the sauna.
Cleaning and Maintenance ●Before using your infrared sauna for the first time, clean the inside of the sauna with a damp cloth. If the smell of the sauna is strong at first, that is normal and please open the door while the sauna is working. The smell will diminish within a weekend. ● Use furniture polish to clean the exterior. ● We recommend placing a soft towel on the floor and on the bench of the sauna to absorb perspiration during sauna use.
Troubleshooting Guide 1 2 3 4 5 6 Problems Power indicator light not on Explanations Power cord is not plug-in Solutions 1. Check for power to the outlet. 2.Check connection between power cord and main control unit. The fuse is burned out Check or replace the fuse. Function The corresponding Repair or replace the control indicator indicator light is panel. light not on broken or burned out. The wiring or some Repair or replace what has failed in electronic component in that circuit.