User's Manual

~ 3 ~

INSTALLATION THE MONITOR

Safety Checks

Make sure the monitor and system unit power switches are off,

when you start connecting cables. This monitor is set for 100-

240 Vac 60/50 Hz (full range). Confirm the line voltage for your

monitor by checking the voltage label on the rear panel of the

monitor.

Figure 3 Connecting the Video Cable and Power Cord

Connecting the Video Cable

The monitor comes with a built-in video cable. To connect the

video cable, follow the steps below:

1. Plug the signal cable’ s 15-pin connector into the computer’ s

video port.

2. Tighten the two screws on the cable connector. As Figure 3.

Connecting the Power Cord

CAUTION: If the AC inlet in your location does not provide

for this type of grounded plug, make sure to install the proper

adapter for a safety grounding.

This monitor comes with a power cord. See Figure 3. Plug