Specifications

Table Of Contents

04-10

INLET MANIFOLD & INLET MANIFOLD &

INLET MANIFOLD &

THRTHR

THR

TTLE BODTTLE BOD

TTLE BOD

The inlet manifold has the fuel injector located on top portion and the throttle body attach to it.

The throttle body has a butterfly valve attached which is operated buy the throttle cables attached to

a drum on the right side.

A manual Bi starter is located on the left side and is the spring and plunger type arrangement.

An idle air bypass screw is provided on the throttle body. It is the large brass coloured screw that is

accessed from the top of the throttle body. The clamps on the throttle body may be loosened and the

throttle body rotated outwards from the top to access the screw without removing the fuel tank and

to adjust the idle speed with the bike running. Turn the screw CLOCKWISE (in) to DECREASE the

idle speed. Turn the screw ANTICLOCKWISE (out) to increase the idle speed. Remember that this

is an AIR BYPASS screw – not a throttle stop screw. Turning the screw about ¼ turn will result in an

approximate 200 RPM change in the idle speed. DO NOT adjust the throttle stop screw on the side

of the throttle body unless you are using the factory software to recalibrate the base throttle opening.