Specifications

03-15
 The tightening torque for M10 lock nut is
2 KG-M. This must be ensured.
 Over size Cam Spindle (For Spares)
570040 : 0.1 mm Over size Spindle
570041 : 0.2 mm Over Size Spindle
CAUTION :
- After the first 800 kms (500 miles) the
backlash between the cam gears must be
checked. If a slight cam noise is observed,
then adjustment of the eccentric sleeve
has to be carried out as mentioned above.
- After adjustment to the required backlash,
both the Inlet & Exhaust lock nut in the
spindle must be tightened to the specified
torque.
 If more or less adjust as follows -
 Initially clean then lubricate chain > EP90
oil and rotate rear wheel.
 Remove split pin and Hex castle nut on the
RH side.
 Loosen Hex lock nut.
 Loosen anchor nut.
 Loosen the brake rod nut
 Turn the adjuster cams on both sides till
25 to 30 mm chain slackness is achieved
 Check and ensure that the number of
notches from the punch mark on the cam
to the notch resting on the pin are equal on
both sides.