Specifications

07-19
3 Remove sprocket drum assy. from the
swing arm along with brake shoes and
cover plate carefully. Disconnect chain if
not removed earlier.
3 Take out sprocket drum, brake shoes,
and spacer
3 Remove the oil seal.
3 Drive out the bearing from the hub
sprocket.
3 Clean the brake shoe & cush drive with
dry cloth / cloth wet with solvent.
INSPECTION
3 Visually check all parts for breaks, cracks,
dents, scoring, glazing or any other
damage.
3 Check bearings for free rotation, axial play
and radial clearance. Replace if necessary.
3 Lubricate bearing by MP grease and then
assemble into sprocket drum by using
bearing punch as shown in Fig.
3 Check the spindle for bend as shown in
Fig.
ASSEMBLY
3 Assemble in the reverse order of
disassembly.
3 While assembling replace the grease seals
and split pin.
CLEANING
3 Clean all parts except brake shoes, cush
drive and tyre, with solvent and dry with
compressed air.