Specifications

07-14
CAUTION :
Do not use high pressure air or any pliers or
sharp objects to remove the pistons as their
working surface can get damaged.
Ensure the pistons do not fly out of the caliper
body due to high air pressure. Support the pistons
Take care not to damage the sides of the piston
as it cannot be reused in case it gets damaged.
Remove he dust seals and piston seals from
the calliper using a blunt tool.
3 Clean the seal grooves with brake fluid.
CAUTION :
Care should be taken to avoid any damage on
the bore of the sliding surface.
INSPECTION
3 Check the caliper cylinder surface and
Piston outer surface for scoring or other
damages.
Measure the caliper cylinder I.D.
Service limit – 25.46 mm
ID
OD
Measure the caliper piston O.D.
Service limit – 25.31 mm
CAUTION :
Enough care should be taken to avoid damages
of the piston O.D. while servicing/ handling.
3 Remove the Bleed screw.
CALIPER ASSEMBLY
3 Coat clean brake fluid on new dust seals
and piston seals and install them in the seal
grooves of the caliper body.
NOTE :
Ensure the piston seal are fixed on the
inner groove and the dust seals are fixed
on the outer groove.