Installation Instructions
6
Cutting
y Carbide edge blades give the best results.
y The use of improper tooling or poor board support
may result in rough cut edges.
y Fine tooth jig saw blades may cause the fusing of
boards together at the cut line.
Routing
y Use standard wood working carbide-tipped router
bits.
y Secure the trim to a bench or table when routing to
minimize “chatter”.
y Once the routing is complete, the cut can be
smoothed using 220-320 grit sand paper. This will
seal the cut edge and make it more resistant to dirt.
Structural Integrity
y Royal trim and mouldings are not to be used as
structural products in load bearing applications. PVC
boards must always be supported by wood or other
structural materials.
y Royal trim and moulding should be stored off the
ground, fully supportHGRQDÁDWVXUface.
y Never place Royal trim and mouldings directly on
blacktop or other surface that can develop
excessive heat.
y Store in a well ventilated area.
y Handle the product with care to avoid damage.
Storage and Handling
Safety
y
Wear safety glasses for all cutting and nailing
operations.
y Follow standard safety practices for using power
tools, ladders, etc.
y Cut and mill in a well-ventilated area.