Installation Instructions

18
&RQFHDO%HDGHG3ODQNLQJ6RIÀW&HLOLQJV
y Conceal Beaded Planking can not be used in load
bearing applications.
y Venting must be added tRVRIÀWVZKHUHDSSOLFDEOH
&KHFNZLWKORFDOEXLOGLQJFRGHVIor requirements.
y Conceal Beaded Planking can span up to 16” un-
supported. For spans greatHUWKDQ6”, a minimum of
/
” substratHVXFKDVSO\Zood or 2X nailing strips must
be installed tRKHOSVXSSRUWWKHSODQNLQJ7KHSODQNLQJ
VKRXOGWKHQEHJOXHGDVZell as oWKHUZLVHIastened to
WKHVXEVWUDWe and framing (Figures 2-4).
y High Heat planking must be used in applications
ZKHUHWKHUHLVSRtential for excessivHKHDWEXLOGVXFK
as porFKFHLOLQJVWKDWFDQQRt be ventHG,QWKHVH
applications, bead board must also be installed over a
minimum of ½” substratHVXFKDVSO\Zood or OSB.
y For porFKFHLOLQJVRUORQJUXQVQDLOLQJPXVWEHPRved
to 12” OC.
y Ro\DOEHDGHGSODQNLQJVKRXOGEHUXQSHUpendicular to
WKHVWUXFWXUHZKHQHver possible tRUHVXOWLQWKH
VKRUtest pieces of material (Figure 1).
y If a seam is necessar\ZLWKLQD·UXQDVKLSODSLV
preferred tRKHOSFRQFHDODQ\VKULQNage.
y FRUDUHDVORQJHUWKDQ·WKHUHPXVWEHDQHxpansion
joint to alloZIRUWKHH[SDQVLRQDQGFRQWUDFWLRQRIWKH
SODQNLQJWKURXJKWemSHUDWXUHFKDQJHV)LJXUH
FDVWening
y FastenerVVKRXOGSHQHtrate 1
/
” into substrate.
y FastenerVPXVWEHZHDWKHUUHVLVWDQWVXFKDVVWDLQOHVV
stHHORUKRt dipped galvanized.
y 3QHXPDWLFJXQVFDQEHXVHG$LUSUHVVXUHVKRXOGEH
adjusted based upon gun, temperature, substrate, etc.
(80-1SVLW\SLFDO
y ,QFROGZHDWKHUEHORZ
0
, pre-drilling ma\EH
necessar\.
y Staples can used.
y 1JDXJH7-nail
y 15 gauge trim nail