Installation Instructions

12
Heat Bending using a Heat Blanket
y Place the two
cement boards side
by side on wooden
blocks to protect the
worktable from heat
damage.
Tool and Material Needs
y Heatcon HC99-300 Heat Forming Kit or Equivalent
y Two 1·3LHFHVRIÀEHUFHPHQWVLGLQJ
y Heat resistant gloves.
y Enough blocks of wood to raise the cement boards
off the work table.
y Template of radius desired.
y Lay one heat blanket
on each of the
cement boards.
y Place the material to
be heated on one of
the heat blankets.
Make sure the “X”
is facing toward the
material to be
shaped.
y Lay the second heat
blanket over the
material.
NOTE: The heating blankets must not touch each other.
Place scrap pieces of trim between blankets if necessary.